Before the advent of computer networks that were based upon some type of telecommunications system, communication between calculation machines and early computers was performed by human users by carrying instructions between them. Many of the social behavior seen in today's Internet was demonstrably present in nineteenth-century telegraph networks, and arguably in even earlier networks using visual signals.
In September 1940 George Stibitz used a teletype machine to send instructions for a problem set from his Model K at Dartmouth College in New Hampshire to his Complex Number Cal...
Users and network administrators often have different views of their networks. Often, users share printers and some servers form a workgroup, which usually means they are in the same geographic location and are on the same LAN. A community of interest has less of a connotation of being in a local area, and should be thought of as a set of arbitrarily located users who share a set of servers, and possibly also communicate via peer-to-peer technologies.
Network administrators see networks from both physical and logical perspectives. The physical perspective involves geographic locations...
Computer networking is the engineering discipline concerned with communication between computer systems or devices. Networking, routers, routing protocols, and networking over the public Internet have their specifications defined in documents called RFCs. Computer networking is sometimes considered a sub-discipline of telecommunications, computer science, information technology and/or computer engineering. Computer networks rely heavily upon the theoretical and practical application of these scientific and engineering disciplines.
A computer network is any set of computers or devices ...
USB communication takes the form of packets. Initially, all packets are sent from the host, via the root hub and possibly more hubs, to devices. Some of those packets direct a device to send some packets in reply.
After the sync field described above, all packets are made of 8-bit bytes, transmitted least-significant bit first. The first byte is a packet identifier (PID) byte. The PID is actually 4 bits; the byte consists of the 4-bit PID followed by its bitwise complement. This redundancy helps detect errors. (Note also that a PID byte contains at most four consecutive 1 bits, an...
The Full Speed rate of 12 Mbit/s (1.5 MB/s) is the basic USB data rate defined by USB 1.0. All USB hubs support Full Speed. A Low Speed rate of 1.5 Mbit/s (187.5 kB/s) is also defined by USB 1.0. It is very similar to full speed operation except that each bit takes 8 times as long to transmit. It is intended primarily to save cost in low-bandwidth Human Interface Devices (HID) such as keyboards, mice, and joysticks. A High-Speed (USB 2.0) rate of 480 Mbit/s (60 MB/s) was introduced in 2001. All high-speed devices are capable of falling back to full-speed operation if ne...